Mel SA 0 Report post Posted March 13, 2018 ATV 1900 pro not working MyGica worked fine up till about a week ago. It wouldnt switch on evem though the the light is on and green. I used the reset button and it worked. Today I came home same problem. It wouldnt switch on it does not connect to my tv. I pressed the reset but it is unresponsive Share this post Link to post Share on other sites
Justin 206 Report post Posted March 21, 2018 On 3/13/2018 at 12:59 PM, Mel SA said: ATV 1900 pro not working MyGica worked fine up till about a week ago. It wouldnt switch on evem though the the light is on and green. I used the reset button and it worked. Today I came home same problem. It wouldnt switch on it does not connect to my tv. I pressed the reset but it is unresponsive Have you tried a different TV? Have you tried a different HDMI cable? Share this post Link to post Share on other sites
Quintin 0 Report post Posted September 26, 2018 I have the same issue. Darn box wont even start up anymore. Green light, flashing amber network light and the red led from the spdif port. My box is 8 months old. Share this post Link to post Share on other sites
tricky 1 Report post Posted September 26, 2018 mine does the same, but i unplug it and plug back in and were good to go Share this post Link to post Share on other sites
Quintin 0 Report post Posted September 27, 2018 Unplugging and plugging back the power does not work on my box. Flashed the latest firmware and the problem is the same. The box will only switch on for about 30 seconds and then goes off. Then you have to unplug the power and wait for about 20 minutes and then switches on for about 30 seconds. Other than that the box is pretty mucj dead. Share this post Link to post Share on other sites
Quintin 0 Report post Posted September 28, 2018 Just update to my previous post. The unit was faulty and replaced. Share this post Link to post Share on other sites
MyGica Support 49 Report post Posted September 28, 2018 Thanks for the update. That sure is weird if it was turning on and showing stuff but went right out. That is usually a hardware issue when that happens. Share this post Link to post Share on other sites