Jump to content
tickielund

KR-303 remote

Recommended Posts

KR-303 remote

Recently bought mygica 1960. Remote was working for about an hour and then it just doesn’t work. The only thing that the system picks up is the standby/off button. I tried re-pairing but it doesn’t work ie no blue flashing light etc. 

Share this post


Link to post
Share on other sites

Hi There,

 

Please try plugging the dongle into another usb slot, or onto another device like a PC to see if they are paired. We just want to make sure that it is the remote and not the USB.

Share this post


Link to post
Share on other sites

Sounds like the battery in the remote is just dead. I had a similar issue with mine and even after charging it didn't work. Later found that because I was using a different cable to charge the remote then what came with it, it didn't have the current carrying capacity to charge it properly. Started using the cable that came with the remote to charge and it worked fine after that.

Share this post


Link to post
Share on other sites
On 4/4/2018 at 12:30 PM, bkwashby said:

Sounds like the battery in the remote is just dead. I had a similar issue with mine and even after charging it didn't work. Later found that because I was using a different cable to charge the remote then what came with it, it didn't have the current carrying capacity to charge it properly. Started using the cable that came with the remote to charge and it worked fine after that.

I'll have to try this myself

And also clarify if the cable it comes with is required to charge the remote

Thanks for sharing this info

Share this post


Link to post
Share on other sites
31 minutes ago, Justin said:

I'll have to try this myself

And also clarify if the cable it comes with is required to charge the remote

Thanks for sharing this info

I wouldn't say the cable that comes with it is required, just one with equal or thicker gauge wire then the one that comes with. The one I was using was thinner gauge before I realized that was the problem.

  • Like 1

Share this post


Link to post
Share on other sites
On 4/16/2018 at 11:05 PM, JohanLouw said:

Must the remote be switched ON at the bottom whilst charging or OFF? How will I know if the remote is fully charged?

For best charging results, turn the switch to "off". However, if you need to use it while it is charging it will just slow down the charging process. It usually take less than two hours to fully charge this device.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×