sauce007 0 Report post Posted September 2, 2014 Hi all, The audio settings for "voice" in MyGica is set to PCM and when I run XBMC to play a stream that contains 5.1 DTS, my AVR is only showing it as Stereo. I did however notice that the audio output settings in XBMC was set to 2.0 so I did change this to 5.1 and still no luck. Another thing I tried was to change from PCM to HDMI in the main settings for the MyGica ATV1200 but that resulted in absolutely no audio, just a loud steady tone. Even when I tried to play a source file from my local storage (USB drive) that has 5.1 audio, the AVR is picking it up as stereo. Any ideas? What should the appropriate audio setting be in the main MyGica settings? Also, what should be the settings in audio output in XBMC? Share this post Link to post Share on other sites
kenand 0 Report post Posted September 12, 2014 I also have a problem with AC3 and DTS trought SPDIF and XBMC. My receiver/decoder receive only laud noise. When play my files with MX player instead of XBMC, I hear good quality 5.1 sound. (But with MX player I can not switch to 2. autio track) Share this post Link to post Share on other sites